NAT Original Packet Tab

Policies : Policies > NAT : NAT Original Packet Tab

NAT Original Packet Tab

•

Policies > NAT > Original Packet

Select the Original Packet tab to define the source and destination zones of packets that the firewall will translate and, optionally, specify the destination interface and type of service. You can configure multiple source and destination zones of the same type and you can apply the rule to specific networks or specific IP addresses.

NAT Rule - Original Packet Settings

Description

Source Zone / Destination Zone

Select one or more source and destination zones for the original (non-NAT) packet (default is Any). Zones must be of the same type (Layer 2, Layer 3, or virtual wire). To define new zones, refer to Network > Zones.

You can specify multiple zones to simplify management. For example, you can configure settings so that multiple internal NAT addresses are directed to the same external IP address.

Destination Interface

Specify the destination interface of packets the firewall translates. You can use the destination interface to translate IP addresses differently in the case where the network is connected to two ISPs with different IP address pools.

Service

Specify the service for which the firewall translates the source or destination address. To define a new service group, select Objects > Service Groups.

Source Address / Destination Address

Specify a combination of source and destination addresses for the firewall to translate.

For NPTv6, the prefixes configured for Source Address and Destination Address must be in the format xxxx:xxxx::/yy. The address cannot have an interface identifier (host) portion defined. The range of supported prefix lengths is /32 to /112.

You must select the Destination Address Translation Type (Policy > NAT > Translated Packet) as Dynamic IP (with session distribution), when you configure the pre-NAT address as FQDN object in Policy > NAT > Original Packet.

Parent topic

Policies > NAT

NAT Rule - Original Packet Settings	Description
Source Zone / Destination Zone	Select one or more source and destination zones for the original (non-NAT) packet (default is Any). Zones must be of the same type (Layer 2, Layer 3, or virtual wire). To define new zones, refer to Network > Zones. You can specify multiple zones to simplify management. For example, you can configure settings so that multiple internal NAT addresses are directed to the same external IP address.
Destination Interface	Specify the destination interface of packets the firewall translates. You can use the destination interface to translate IP addresses differently in the case where the network is connected to two ISPs with different IP address pools.
Service	Specify the service for which the firewall translates the source or destination address. To define a new service group, select Objects > Service Groups.
Source Address / Destination Address	Specify a combination of source and destination addresses for the firewall to translate. For NPTv6, the prefixes configured for Source Address and Destination Address must be in the format xxxx:xxxx::/yy. The address cannot have an interface identifier (host) portion defined. The range of supported prefix lengths is /32 to /112. You must select the Destination Address Translation Type (Policy > NAT > Translated Packet) as Dynamic IP (with session distribution), when you configure the pre-NAT address as FQDN object in Policy > NAT > Original Packet.